In Store Only

Use HI TECH Trim Paints with confidence to refinish exterior auto trim and bumpers to factory O.E.M. specifications. Trim Black is self-etching and designed to be applied and re-coated with a minimum of surface preparation.

Directions:

• Surface to be painted should be scraped to remove flaking paint and then sanded with 400-600 grit sandpaper. Surface MUST be free of silicones, waxes and oils. HI TECH's SUPER SOLV is ideal for this task.

• Protect all adjacent areas with masking paper to prevent over spray damage.

• SHAKE WELL - Proper mixing requires at least one minute of continuous shaking once ball can be heard.

• For best results, hold can 6-12 inches from surface and apply in sweeping motion. Avoid runs and drips by applying several thin coats.

• Allow 5-10 minutes between coats.

• Clean nozzle immediately after use. Turn can upside down and spray until clear.

• If spray nozzle clogs, pull off and clean. DO NOT stick pins or other wire-like objects into can opening. Discard empty can in approved trash receptacle. Do not burn, incinerate, or place in home garbage compactors.