Nanoskin Autoscrub system works fast and achieve professional results with the new advanced rubber polymer technology, which replaces the use of clay bars. With either dual action orbital polisher or hand application, it safely and easily removes paint overspray, water spots, fresh tree sap, rail dust, and other bonded surface contaminants from the surface of automotive paint, glass, moldings, and plastic. Unlike the clay bar, the AUTOSCRUB can be cleaned by simply rinsing off the accumulated contaminates with water. If you drop the AUTOSCRUB on the ground, no worries, just rinse the sponge pad clean and you're ready to keep using it. Easy glides allows for sturdy and controlled handling, unlike clay bars where constant reshaping is required.

*For surface preparation, use with Super Suds or Cherry Soap.

Directions

Use ONLY on clean, cool paint and out of direct sunlight. DO NOT work on surface over 120 degrees F. Please use in an inconspicuous place for the first time in case of unexpected adverse effects on paint surface.

1. Mix 1 oz of Super Suds or Cherry Soap per gallon of water.

2. Rinse Surface with water and clean with Super Suds or Cherry Soap & a wash mitt, then rinse with water again to flush away loose dirt.

3. Apply AUTOSCRUB Wash Mitt with Super Suds or Cherry Soap using light pressure.

4. Begin with the roof, and work the suds down to the hood, trunk, and sides.

5. Rinse with clean water.

6. Dry with clean and soft towels.

NOTE:

Sufficient lubrication is crucial to the AUTOSCRUB application.

Plain water is NOT an adequate lubricant.

AUTOSCRUB is not solvent resistant.

Remove tar & grease before application

HELPFUL TIPS:

The AUTOSCRUB has a protective coating to ensure stability within transportation.

To break in the pad, moisten the AUTOSCRUB with desired lubricant.

Moisten a portion of window glass or other glass surface. Rub AUTOSCRUB in circular motion against the glass for 30~60 seconds. You may see a white soapy foam. This is the protective sealant coming off.

Do not use until the polymerized rubber is soft and slightly tacky.

Cold temperatures may stiffen pad. Warm surface before using.